Abstract:
In Uganda conventional water treatment plants face major challenges in terms of assessing
their operation and performance due to inappropriate technologies, insufficient equipment
and deficiency in skilled expertise. Simple but efficient technologies are therefore necessary
for reasonable evaluation of the daily performance of the plant. In this study the performance
of National Water and Sewerage Corporation water treatment plant, Tororo was assessed.
The study was conducted by assessing unit process capability, design, operation and maintenance potential to meet optimized goals. From results of the assessments, root factors
limiting optimum performance were identified and improvement options were proposed. The
results of the assessment found that with all units at full operation the plant had the capability
to satisfactorily treat water at peak daily demand of 2300 m3/day. The assessment results
indicated that, settled water turbidity was measured less than 10 NTU. And filter turbidity
spike of 6.5 NTU following backwash with a reduction to 0.6 NTU after one hour was
observed. Jar test experiments were conducted to evaluate the effectiveness of Aluminium
Sulphate and Polymer (recently used by the treatment plant) by comparing the optimum dose
for highest turbidity removal and relative costs. From the jar test results Aluminium Sulphate
was found to be the effective chemical with 27 mg/l optimum dose mixed with 13.56 mg/l of
Polymer. Results of the analysis showed that all of the measured parameters were within the
acceptable range. In the assessment of factors limiting performance of the treatment plant;
major factors were categorized as design, operational and maintenance. No single factor was
responsible for poor plant performance, although in general the study found that all factors
influence the plant’s ability to work properly. Some of the primary operational problems and
the intake structure’s adequacy significantly affected performance. Operational factors were
found to have the highest rank. This finding, coupled with the fact that the plant had adequate
capability, indicates that improving process control could significantly improve performance.
